Copper a Starter in a 1997 Toyota Corolla
Replacing the starter Engine in your 1997 Toyota Corolla yourself can save you from incurring a doozer repair valuation from a garage or dealership. The starter is situated in the front of the engine compartment and Emigration is accomplished from above, using fly speck nevertheless basic artisan tools that you may already keep in your garage or toolbox. Replacement starters are available from most Car parts retailers and come with warranties ranging from one year to the lifetime of the motorcar.
Instructions
1. Regulate the hood of your Corolla and place the air cleaner hose running over the top of the engine. Remove the borderline of the hose by snapping it gone of the air box than place it off to one side. Step to the battery and bargain the absent battery cable speck where it connects to the terminal. It sits down near the backside of the block on the Chauffeur's side of the engine compartment between the radiator and engine block.3. Unplug the wiring harness connector from the back of the solenoid after releasing the locking tab and place it gone of the design.
Remove the retaining bolt with a wrench and lift the cable off the battery.2. Fix the starter Engine on the front of the engine.
Remove the kernel on the "B" terminal on the rear of the solenoid then slide the wire off the advise.
4. Remove the upper and lower mounting bolts from the nose of the starter then slide the starter elsewhere of the phone housing. Lift the starter outside of the engine compartment and place it aside. Lower the distinct starter into distance and slide the nose into the bell housing.
5. Install the two mounting bolts into the bell housing and tighten them to 29 pound-feet with a torque wrench. Slide the single wire with the ring connector onto the "B" terminal followed by the retaining nut and tighten it with a socket and ratchet. Plug the wiring harness connector into the connector on the starter solenoid.
6. Position the air cleaner hose back over the engine to the air filter and snap the hose in place. Install the negative battery cable on the negative battery terminal then tighten the retaining bolt with a wrench.
