The 1996 Toyota T100 pickup starter Engine is located on the Chauffeur's side of the engine, attached to the phone housing near the back of the engine. Whether your starter is not working or is skipping, dragging or forming grinding noises, it may be future for a advanced starter Engine. Antecedent, bench comp the starter gone of the T100 to cinch its context. Most Car parts stores Testament bench test your starter at liberty provided you remove it.
Instructions
1. Disclosed the hood and disconnect the detrimental battery cable from the denying battery post using a wrench. To avoid a short or injury, isolate the battery cable so that it can't accidentally touch the battery publish while you are working on the electrical components and starter.
2. Jack up the front of your T100 and position a establish of jack stands under the front of the Motor lorry to cooperate it. Slide under the Chauffeur's side of the engine and allot the starter.
3. Remove the electrical wiring connectors from the starter. Push in the locking tab on the push-in connector and pull the connector from the terminals on the back of the starter. The moment terminal is a stud with a wire and aficionado on it; benefit a socket to remove the devotee, then slide the wire off the terminal.
4.6. Install the plug-in connector on the terminals of the new starter. Push the connector onto the terminals until the locking tab snaps into place.
5. Install the two mounting bolts in the nose of the dewy starter and tighten them with a socket and ratchet. Install the wire on the stud terminal on the starter, followed by the retaining stone. Tighten the nut with a socket and ratchet.
Remove the upper and lower mounting bolts on the nose of the starter while supporting the starter by participation to accumulate it from falling when it becomes loose. Remove it. Lift the fresh starter up and into the spot where the ancient starter came absent. Raise the front of the truck with a jack to remove the jack stands from under the truck, then lower the truck to the ground.
7. Install the negative battery cable onto the battery terminal and tighten the retaining bolt with a wrench.
