A grinder with the take trundle can easily grind tungsten carbide.
Tungsten carbide is a very hard information untrue from tungsten and carbon. It is commonly used for the tips of tools, remarkably cutting tools. While this counsel is very hard, it does develop into worn over day and may want grinding or sharpening. Carbide tools and tips can be ground with a diamond grinding revolve, on the contrary grinding a baggage evenly requires skill and experience.
Instructions
1. Remove the tool from remainder, then turn on the grinder. Touch the tip of the tool to the moving wheel, just as you did before when determining the angle, and use remainder to guide the angle of the grinding. Carbide may emit short red sparks during grinding.
Touch the tip to the wheel, but do not turn on the grinder yet. Adjust remainder as needed so that you achieve the necessary grinding angle for your particular tool. Many rests will allow you to adjust both the height and the angle of remainder.
3. Attach the diamond rotate to your bench grinder. Cite to your manual to ensure that the wheel is properly attached and the grinder itself is appropriately mounted.2. Hold your tungsten carbide tool against remainder beneath the wheel. These are normal. The carbide tool may also become very hot. Work in short intervals and do not burn yourself, overheat the tool or touch the tool immediately after grinding. Continue grinding until the tool is sharpened.
