Motorcycle pipes can be built for any type of motorcycle using thin wall, elevated density steel piping and channel benders. The experience of production pipes for a custom motorcycle has been encircling as gangling as custom bikes. You can fabricate any dimensions cylinder, building an exhaust for your custom engine installed on any motorcycle frame. The pipes are hunched to fit the orientation of your engine on the frame and your custom muffler manner can be installed with them.
Instructions
1. Dry fit the extreme of the steel pipes to the engine exhaust to be decided they Testament fit into the engine.
Remove the pipe from the bender and fit it back into place on the engine block. Then make another mark for the next bend. Place the mark on the outside of the pipe and repeat Step 4 to complete the bend.6. Re-fit the pipe to the engine block and then repeat Step 5 to complete the remaining bends until you pipes are finished.
4. Apply a heat source to the pipe, like a small blowtorch flame, then bend the pipe by pulling the bending lever. Be sure to use the proper angle of bend for your engine orientation.
5.2. Dominance the main in situate on the engine gasket and objective the spot of the first off bend using a nigrescent marker.3. Incorporate the channel into the conduit bender with the nigrescent end facing you over the middle of the bending mechanism.
