Fiberglass boat fenders might match your deck or complement your hull colour.
Repairing a fender, the bumper you hang between boat and pier, is a mini project. Repairing the gel-coat finish on a fender is an all the more smaller project, on the contrary even one to be attacked as whether it's your dialectics for living. The gel-coat Stop Testament not cure while exposed to air, so it's vital that you insert the fender in an air-tight cocoon while it dries.
Instructions
1. Sand the surface of the fender with 220-grit sandpaper, to cede the gel-coat a surface to which it can adhere.
2. Dispense 1 ounce of gel-coat resin for Everyone square inch of the gel-coat Stop that requires repair into a Disinfected plastic Mug.
Stir up all of the resin from the backside, sides and corners of the Mug -- to confirm the hardener and resin are thoroughly mixed.4. Spread the gel-coat resin onto the earth requiring repair on the fiberglass fender by using a plastic spreader, cherish those begin in emulsion shops.3. Add 4 drops of the gel-coat hardener to the Mug for Everyone ounce of gel-coat resin. Compound the resin with a clean plastic picnic edge.
Whether it bulges, great; it will shrink as it cures.
5. Wrap the fender in plastic wrap. Secure the plastic wrap with duct tape. Tape the edges of the plastic wrap down, to exclude air from the repaired area.
6. Allow the gel-coat to cure for Day and night. Remove the plastic wrap and lightly sand the area with 600-grit sandpaper. Clean away the sanding dust. Wax the fender with automotive paste wax. Hand buff the fender with a soft, clean cloth until it displays a mirror finish.
