One of the weakest points of a pickup Motor lorry is the lower rear corner of the cab. It is always the ahead assign to rust elsewhere, now the vehicle is exposed to dilute and course of action bite at that specific site. To complicate things, the workshop bleed holes Frequently plug with dirt, allowing those corrosive elements to build up and rust the metal elsewhere. Happily, you conclude not corner to be trained intent adult to allot a rusted cab corner.
Instructions
Rugged up the glue areas with a correct Rugged grit sandpaper, on both the vehicle and inside the patch panel. Disinfected all sanding dust off the vehicle and the inside of the patch panel.4.
Remove all the damaged metal and as even of the other metal as likely within the outline of the replacement corner by cutting it with a Dremel factor, or something alike, that has an abrasive spin mounted to it. Go-ahead Sufficiently of the introductory metal on the sides and front of the cab corner to epoxy the patch panel to the cab.
3. Remove all the stain from the corner in the nature where the patch panel Testament birr by sanding it off with sandpaper.1. Clasp the patch panel, which is slightly thicker than the introductory stage metal on the object and shaped conforming the corner of the cab, against the vehicle and outline the patch panel with a permanent marker.2.
Mix a batch of epoxy large enough to cover all the glue areas on the patch panel and cab corner. Spread the epoxy on the roughed-up areas of the vehicle and the roughed-up edges of the patch panel with a Popsicle stick. Fit the patch panel to the vehicle.
5. Slide a 2-by-4-inch block of wood between the cab and the truck bed at the top and bottom of the patch panel. Hold them in place by wedging a wooden trim wedge between the patch panel and the truck bed.
6. Hold the bottom of the patch panel to the bottom of the truck body by placing a pair of vise grips at either end of the bottom of the patch panel where the panel and body meet. Clamp them together. Wipe off any epoxy that squeezes out of the seams between the patch and vehicle body. Allow the epoxy to establish for 24 to 48 hours.
7. Cover the seams on the front and back of the panel patch with auto body caulk. Cover the seams that are always visible with body filler. Allow the body filler time to dry, and feather the dried body filler in the seam with sandpaper so that the patch and vehicle's body look as if they are one, completing the repair of the cab corner.
