Exchange a Honda Permit Door Lock Actuator
Late-model Honda Correspond door lock actuators are integrated into the door bolt mechanisms. They can be separated from the door bolt. They hold been commence to be susceptible to corrosion due to moisture. Whether the door locks effort on assorted doors, the door lock mechanism is possible malicious. Whether none of the door locks guide, the fuse should be checked, followed by the crack window switch in the Chauffeur's door.
Instructions
1. Remove the side design mirror bolt concealment include by pulling it off. Remove the screw in the plastic filler include forward of the inside door grip, using a Phillips screwdriver. Remove the screw located in the recessed tool of the armrest, which is attached to the window switch, using a Phillips screwdriver. Lift the plastic recess up and the window switch Testament lift up with it.
2. Disconnect all the electrical plugs from the back of the window switch. Remove the screw in the inside door handle that secures it to the door, using a Phillips screwdriver. Pull the door holder outside and outside from the door Sufficiently to disconnect the two door bolt actuating rods from the rear of the door bail. Push the plastic retainers gone from the rods and lift them absent.
3.4. Disconnect the electrical plugs from the door bolt. Remove the two rods from the rear of the gone door handle in the same manner as the inside handle. Remove the three large Phillips screws securing the door latch to the rear of the door.
Remove the door panel by placing the universal screwdriver between the door panel and the door at the lower rear limit and prying all the trim fasteners elsewhere of the three sides of the door panel. Remove the panel. Peel the moisture shield back to expose the door fastening. Remove the door latch/door lock mechanism from the inside of the door.
5. Remove the screws securing the door lock mechanism to the door latch and remove the door lock actuator. Replace all parts in reverse order of removal.
