Provided you properly prolong your Ford Explorer's sunroof, you can dote on the unfastened air in first-class weather and eliminate leaks and squeaks. It's generally recommended you Disinfected and gaze your sunroof's rubber seal at least twice a year.
Instructions
Install a New Rubber Seal
1.10. Access the tracks and seals of your Ford Explorer's sunroof by removing the interior trim and letting the roof cover drop. You don't need to completely remove it, just let it hang.
Allot them aside so you can reinstall the sunroof consequent. Disconnect the aptitude from the rear of your sunroof.
3. Pull the sunroof up and elsewhere from the Motor lorry. You may duty the nourishment of another human race for this bother, to avoid dangerous the sunroof or the Motor lorry.
4. Operate the plastic scraping effects to lift off the antique rubber seal. Disinfected any excess rubber or adhesive from the channel, then and probation the channel for rusting. Provided you gaze rust, stain the channel with Rustoleum to prevent besides decay.
5. Install the latest rubber seal into the channel, commencement with the outer lip and then Stirring to the inner lip. Look the seal for bumps or wrinkles. Provided you gem any, lift the seal outside of the channel and reinstall it. Conduct doing this until the complete seal sits evenly inside the channel.
6. Country the sunroof back on top of the Motor lorry and reconnect it using the screws and bolts you removed earlier. Grasp checking to brew decided it's akin. Cite to plug the power source back in so your sun roof will fully function.
7. Return the headliner and the interior trim back into position.
Maintain Your Sunroof
8. Inspect the exterior of your sunroof of your Ford Explorer on a monthly basis. Look to make sure it's evenly seated, not lifting at one corner. Lifting indicates it's time To cleanse and lubricate the tracks.
9. Check the draining tubes for your Ford Explorer. Two drain to the front of your vehicle, typically beneath the fenders. The other two drain to the rear of your vehicle, usually behind your tail lights. Use compressed air to blow out any debris, dust or clogs.
Unfasten the screws that secure the interior trim and headliner. You should bear filled access to the sunroof on both the interior and exterior of your Ford Explorer.2. Loosen and remove the screws and bolts that fasten the sunroof to the top of the Motor lorry. Use compressed air to remove debris, then lubricate the tracks with 3-In-One lubricant.
11. Lubricate and clean your rubber gasket. Wipe them off with a lint-free cloth, then use the lubricant outlined in your owner's manual. If your seal is stiff or show signs of excessive wear, replace it so your sunroof doesn't leak.
