By Ifcar
The Ford Ranger is a bantam pickup Motor lorry available with three antithetic engine configurations. The Ranger has not been majorly redesigned by reason of 1994, so most repair directions for 1994 and newer vehicles Testament be basically the identical. Attain to copper the thermostat in your Ford Ranger, regardless which engine it has.
Custom the socket wrench to remove the thermostat and its gasket. Wipe the are clean with a rag and discard the old gasket.4.
2. Remove the engine brush guard from underneath the engine bay (provided equipped) to access the radiator filter plug. Remove the bleed plug and let the engine coolant completely extract into the affliction. Conserve the coolant absent from children and animals. It is highly poisonous.
3. Remove the wiring harness from the rear of the thermostat (located endure the radiator).
Instructions
1. Arena your Ranger on equable ground in an world costless of distractions. Disconnect your denying battery cable and let the engine frigid off for at least 30 minutes.Mount the new thermostat and gasket to the radiator with the torque wrench. The proper torque level for the Ford Ranger is 89 inch-pounds for four-cylinders and 4.0 L V6 engines. The proper level for the 3.0 L V6 engine is between 15 and 22 foot-pounds.
5. Replace the drain plug, wiring harness and engine coolant. Reconnect the negative battery cable and start the engine to check for leaks. If there are no leaks, replace the engine brush guard.
