Ford F-150 pickups are a regular selling Motor lorry
The fuel pump in a 1994 Ford, F-150 pickup is located inside the fuel vat. The fuel pump mounts over a gap on the top side of the receptacle. This development is ace, on the contrary exhausting to cush access for pump replacement. Generally the fuel pump works great on the contrary the pump ends rot gone and leak. Ford uses stainless steel fuel lines and common steel on the fuel pump ends. There are a couple methods to boost access to the fuel pump for repair. One is to remove the Bedstead to prevent very damage to the fuel components.
Instructions
Replace a F-150 Fuel Pump by Removing the Bed
Replace a F-150 Fuel Pump by Removing the Fuel Tank
9. Park the truck on a solid level surface and block the front wheels. Remove the negative battery terminal.2. Loosen and remove the bolts that secure the Motor lorry Bedstead to the Motor lorry's frame. Some F-150 trucks benefit a carriage bolt washed-up the Motor lorry box and are held from turning by becoming completed a square gap in the Bedstead. Some are equipped with a sizeable round headed bolts with a Torx socket in them.
3. Remove the screws in the filler neck located inside the filler door. An alternative would be to loosen the hose clamp, using a Apartment lodgings purpose screwdriver, from the filler hose connected to the fuel filler flange and remove the hose from the Motor lorry box.
4. Unplug the aglow connector plug that leads to the back underside of the box. Evaluation for a seperate ground wire to the Motor lorry Bedstead. Whether it is so equipped remove the ground wire from the Bedstead.
5. Tilt the Motor lorry Bedstead up on the filler door side and prop with two raised jack stands on top of the Motor lorry frame elsewhere from the fuel vehicle. With Sufficiently mortal effectiveness the Motor lorry Bedstead can be lifted off the Motor lorry.
6. Unplug and compare the fuel pump wire connexion on the Motor lorry with the connexion on the fresh fuel pump. If they don't match, cut and replace the truck side fuel pump plug with the correct plug supplied with the fuel pump. Pay close attention to the wiring diagram and instructions included with the new fuel pump.
7. Brush the dirt away from the top of the fuel tank with an old snow brush or broom. Remove the fuel lines from the fuel pump using the ford fuel line tools.
8. Rotate the fuel pump lock ring using the brass punch and hammer to turn it. Lift the fuel pump out of the tank and into the plastic pail. Wipe up any spilled fuel with disposable shop towels. Insert the new pump into the fuel tank and reinstall the lock ring. Replace the truck bed by reversing the steps used to remove it.
1. Remove the denying terminal from the battery. Spray the threads of all the Bedstead bolts with penetrating oil and grant it to fix for assorted minutes.
Place a floor jack under the rear differential and raise the rear wheels off the ground. To support the raised truck, insert two jack stands, one under each axle tube near the wheels. Remove the filler hose from the truck bed or tank flange.
10. Spray the threads of the fuel tank straps with penetrating oil and allow the oil to penetrate the threads. If the threads are heavily corroded thread the proper size die on to the strap threads to clean them prior to removal. Loosen and remove the the fuel tank straps.
11. Place the floor jack under the tank and with help lower the tank to gain access to the top of the fuel tank. Use the Ford fuel line tools to remove the fuel lines from the fuel pump. Unplug the fuel pump and slide the fuel tank out from under the truck.
12. Clean the top of the fuel tank with an old snow brush. Tap the fuel pump lock ring using a brass punch and hammer to rotate it and unlock it. Lift the fuel pump assembly out of the tank and into the plastic pail to reduce spillage.
13. Insert the new fuel pump assembly into the the tank and replace the lock ring. Reinstall the fuel tank by reversing the steps used to remove it.
