General automotive electric fuel pump.
The electric fuel pump in your Hyundai Accent provides the needful fuel strength to provisions the engine combustion Hospital ward. On the other hand, worn pump bearings or defective pump valves may author low or higher than standard fuel coercion. In such process, you compulsion to transform the pump.
Instructions
Relieve the Fuel System Pressure
1. Remove the rear seat cushion by pulling on the retaining strap located In relation to the back of the seat. Then pull the seat upward.
2. Pull the access door panel on the floor by pulling the door concluded the gap with your finger or a screwdriver.
3. Unplug the fuel pump module connector by urgent on the lock tab and pulling the plastic connector from the harness.
4. Remove the fuel pump from the meeting.
Install the New Fuel Pump
13.Turn the ignition switch off.
Remove the Fuel Pump
7. Disconnect the coal, denial battery cable using a wrench.
8. Disconnect the fuel work, answer and vapour lines from the fuel pump/sending unit meeting by urgent on the lock tabs of the plastic connectors. Duty concluded the door access panel.
9. Unplug the fuel sender connector by urgent the lock tab and pull the connector off its harness.
10. Unscrew the lockring holding the fuel pump/sending unit meeting onto the container using a spanner wrench. Turn the lockring counterclockwise until the call is released.
11. Lift the fuel pump/sending unit assembly off the fuel vat life careful not to damage the sender unit interval arm.
12. Bow the engine and let it lazy until it stalls.5. Eccentric person the engine for approximately 3 seconds.6.
Mount the modern fuel pump on the pump/sending unit assembly.
14. Set the pump/sending unit assembly in the tank with the sender unit extension arm pointing towards the rear of the fuel tank. If provided, make sure any arrows or marks on the pump/sending unit assembly flange align with the arrow or marks on the fuel tank mounting base.
15. Lock the pump/sending unit assembly in place by turning the lockring clockwise using the spanner wrench.
16. Plug the fuel sender connector.
17.Connect the fuel supply, return and vapor lines.
18. Replace the access panel door.
19. Install the rear seat cushion.
20. Connect the black, negative battery cable.
