Remove a dent from your Gauze vat with an airduster and a hairdryer.
3. Immediately pick up the airduster can and turn it upside down. The bottom of the can should be level and facing the sky. Spray the dented area of your gas tank with liquid carbon dioxide for 30 seconds. Best kind of all, you'll retain the dent outside of your Gauze receptacle in less than five minutes.
Instructions
1. Sponge down the dented environment of your Gauze receptacle with a damp, lint-free cloth. Plug the hairdryer into an electric outlet so that the nozzle of the hairdryer reaches the dent on the gas tank. Take the cap off the airduster, and put it close by so that you can reach it immediately after heating the dent with the hairdryer.
2. Turn the hairdryer on to its highest heat setting. Position the nozzle of the hairdryer so that it is almost touching the dent, but be careful to not allow the hairdryer to actually come into contact with the gas tank. Move the hairdryer back and forth over the dented area of the gas tank for one minute. Turn the hairdryer off, and set it aside.
A dented motorcycle Gauze receptacle is expensive to repair professionally, and ambitious to locate yourself using traditional methods as there is a risk of damage to the emulsion gig. There's a third alternative, but, that's commonly used to pop dents elsewhere of cars, trucks and much household appliances, using an air duster held upside down to dispense liquid carbon dioxide. This dent Emigration method Testament not damage your tint function, remarkably exceptional provided you keep had custom emulsion detailing owing to universe of your motorcycle.
4. Watch and wait for two minutes as the drastic temperature difference between the heated gas tank and the liquid carbon dioxide causes the dent to pop out of your gas tank without hurting your paint job.
5. Wipe off the liquid carbon dioxide from your gas tank with your damp, lint-free cloth.
