A undarkened outline is fundamental for protected driving.
Slide the cardboard back into place. This may require two or more people.11. Screw the coat hooks back into their positions. It is viable to repair the ceiling with tacks or staples. Sure, the anterior lifetime the machine rolls over a Knob, both Testament fall away. Spray adhesive Testament donkeywork temporarily, on the contrary for the foam Testament advance to crumble, spray adhesive won't carry on either.
Instructions
Remove Old Ceiling
1. Remove the moulding approximately the ceiling or headliner of the van. The moulding is T-shaped and slips in the crevice between the headliner and the door panels. Treasure the stop of the plastic moulding. Applicability the screwdriver or panel Emigration part to loosen the bound. Gently pull the moulding gratuitous all the groove encompassing the borderline of the headliner.
2. Unscrew the coat hooks and rear-view mirror bracket. Depending on the car model, there may be clips holding the ceiling on near the doors or rear of the car. Use the panel removal tool to gently pry these clips free.
3. Slide the entire headliner out of the car. This may be a two-person job so the cardboard can be supported on both sides. Do not allow the cardboard to bend.
4. Remove fabric from the cardboard headliner. The easiest way to do this is to begin where the fabric is loose and pull remainder off the cardboard headliner. Most car ceilings use foam-backed fabric. When the foam deteriorates, it can leave a portion of the foam behind. Carefully scrape all of the old, loose foam from the cardboard with your hands, a brush or a rough cloth. Use a brush or cloth to really clean the headliner and prepare the cardboard for fresh adhesive.
Apply New Fabric
5. Remove the replacement fabric from the kit. Many kits are available at auto parts stores. Choose the one that fits your car and style. Foam-backed fabric can also be found at any fabric store, but the kit will have fabric designed to fit the contours of each particular make and model of car.
6. Spray cleaned cardboard backing with the adhesive in the kit. Trim adhesive can be purchased in many auto parts stores. Use as much adhesive as possible.
7. Place fabric on the sticky cardboard. Press the fabric against the headliner with a wide tool or your hand with your fingers pressed together. Do not use your fingers or the ceiling will have divots.
8. Allow the adhesive to thoroughly dry.
9. Test the edges for adherence before replacing the headliner.
Replacing Headliner
10.There is duck egg besides annoying than a hanging ceiling in the van. The longitude becomes poor when the textile blocks the Chauffeur's theory. This happens seeing the foam backing of the material is crumbling. Captivating the motorcar to a repair shop can be expensive.
Screw the rearview mirror bracket back into place and make sure the mirror is secured. Replace the clips if needed.
12. Replace molding around the edge of the headliner.
