Friday 25 December 2015

Use A Felpro Exhaust Manifold Gasket

Federal Lord is an American collection that manufactures and distributes automotive replacement parts and accessories under many clashing Trade-mark names. Fel-Pro is the Trade-mark agnomen used by Federal Lord for its premium sealing systems. A Fel-Pro exhaust manifold gasket is used to seal a vehicle's exhaust manifold to the engine. Without a deluxe seal at this junction, exhaust gases could enter the passenger compartment.


Instructions


1. Sincere the hood and authorize the exhaust method to arctic for one day provided the engine has recently been gallop. Place the exhaust manifold on the side of the engine block. Accumulate in imagination that V-6 and V-8 engines hold one exhaust manifold on Everyone side of the engine.


2. Loosen and remove the retaining bolts from the exhaust tube that is attached to the underside of the exhaust manifold with a socket and ratchet wrench.


3. Loosen and remove the retaining bolts that attach the exhaust manifold to the cylinder sense of the engine with a socket and ratchet wrench. Spray the bolts with penetrating fluid whether they seem cussed and let on it to soak in for diverse minutes before attempting to loosen the bolts again.


4. Action the exhaust manifold gone from the cylinder sense honest far Sufficiently that the Fel-Pro gasket can be inserted in between the manifold and the mind. Pry the manifold carefully with a pry bar, provided vital.6. Push the exhaust manifold against the cylinder head. Start the manifold retaining bolts by hand to prevent cross-threading.



Handle care not to mar the mating surface of the manifold.5. Insert the exhaust manifold gasket with the steel side facing the exhaust manifold and the fiber side of the gasket facing the cylinder head. Ensure the mounting holes in the gasket line up with the holes in the manifold and the cylinder head. Tighten the bolts with a socket and ratchet wrench.


7. Lift the exhaust pipe back into position on the underside of the manifold and thread the retaining bolts in by hand. Tighten the bolts with a socket and ratchet wrench.