Building with PVC, a ambidextrous building information, Testament want you to drill holes in the PVC tubing, which Testament authorize any fastening materials to pass buttoned up easily. Drilling into PVC employs the alike types of tools as drilling into wood. Unlike most wood, on the other hand, PVC is hollow and can crack provided you manipulate besides all the more compel. Operate a sharp drill bit combined with the fitting balance and vigour to shorten the chances of cracking the PVC tubing.
1. Custom the tape degree to catch the particular point on the PVC tubing where you commitment to drill, and objective it with a permanent marker.
2.4. Center the drill bit over the mark you made on the PVC tubing in Step 1. Hold the drill perpendicular to the PVC tubing, and drill a hole.
Insert the drill bit into the drill motor. Secure the PVC pipe into the vise. Do not exert excessive pressure on the PVC tubing. Tighten the vise to a degree that prevents the PVC pipe from moving---no further.
Degree the fastener with the tape measure. Choose a drill bit 1/16 inch larger than the diameter of the fastener. For example, a 1/4-inch-diameter bolt would require a 5/16-inch hole.3. If the hole needs to pass through both sides of the PVC pipe, hold the drill absolutely straight before you drill through the other side.
5. Remove the burr left on the PVC tubing that surrounds the drilled hole using the utility knife. Place the tip of the knife blade onto the burr. With the knife tilted at a 45 degree angle, gently cut the burr from the surface of the PVC tubing. Scrape the area around the hole after you have removed the burr to smooth out the area.
6. Remove the PVC pipe from the vise and insert the fastener through the tubing.