Adjust the Emergency Brake for Rear CD Brakes on a Nissan 240SX
The Nissan 240SX comes equipped with four trundle CD brakes. The rear CD brakes side an actuator caliper originate that provides an emergency brake assistance when the actuator is rotated by the emergency brake lever and cable meeting. The calipers in this process are self adjusting, on the other hand cannot compensate for the stretch that occurs in the emergency brake cables. Adjusting the emergency brake cables Testament restore Correct overhaul to the development.
Instructions
1. Accommodation trundle chocks at the end the front wheels. The Nissan 240SX is a rear turn ride motorcar. When the rear wheels are raised off the ground, the vehivle is autonomous to roll backwards. Spin chocks are a binding safety reason when raising this vehicle. Lift the rear of the Nissan until the rear wheels are off the ground with a floor jack and distance jack stands under the rear frame. Lower the 240SX onto the jack stands.
2. Tighten the nut until the lever meets strong resistance to movement after six clicks.3. Apply the parking brake and check the rear wheels again, to see if they are locked down. Replace the lever cover, the console and lower the rear of the car. Whether the wheels deed with share pressure, adjust the parking brake lever. Lower the parking brake lever. Turn the 10mm adjuster nut that attaches the parking brake cable to the parking brake lever clockwise. This nut is located on the cable stud angled forward at the base of the lever assembly. Remove the centre console by using a screwdriver to remove the retaining screws that attach the console to the transmission tunnel, and lifting it up and over the parking brake lever. Remove the parking brake lever insert and pull up on the lever six to eight clicks. Six to eight clicks should lock the wheels. Crack to spin the rear wheels.
Test drive to verify.
