Authority windows are a convenience circumstance for lots of vehicles on the course nowadays, and when they snap elsewhere, it can be beautiful inconvenient. Then pull off the interior mirror trim quota with your hands.3. Push the door panel up In relation to the headliner, using your hands, and then pull the door panel off of the door.
1. District the flathead screwdriver between the lock Press-stud and the door panel, then twist the screwdriver to pop outside the door lock trim. Repeat this course for the trim encompassing the interior pull stem and the capacity window switch panel. Unplug the capacity window switch panel, using your hands.
2. Unbolt the door panel from the door, using the 1/4-inch ratchet and socket place. The bolts are in the corner near the armrest, and ultimate the door lock. Generation was, replacing a window regulator was a certain misery, on the contrary on the 1999-2006 Silverado, the mode has shift a quantity easier. Promptly, the regulator is on a cable transaction, and can be pulled elsewhere of the door in minutes. In this contingency, the project vehicle is a 2004 Chevrolet Silverado, on the contrary the action is congruous for other vehicles.
Instructions
4. Plug the power window switch back into the harness on the door and roll down the window to the nearly speck. There are two clamps on the window channels that clasp the window in settle. Unbolt them, using the 3/8-inch ratchet and socket, then tilt the back of the window up In relation to the front of the vehicle and pull the glass outside of the door In relation to the interior, using your hands.
5. Unbolt the bolts that secure the window channels to the door, using the 3/8-inch ratchet and socket. Then unbolt the window regulator Engine from the door. Unplug the efficacy window regulator motor harness from the door too. Fold the channels together so that the channels, cables and window regulator motor can fit through the access panel, and pull out the assembly.
6. Slide the replacement power window assembly into the door panel and bolt it in place, using the 3/8-inch ratchet and socket. Reinstall the glass in the reverse order of removal, and tighten it down to the regulator, using the 3/8-inch ratchet and socket.
7. Plug the wiring harness back into the switch panel and test the window's up and down movement. If it binds in any way, adjust the window, or consider reinstalling the assembly, as the cables may be twisted.
8. Reassemble the door panel in the reverse order of disassembly.
