Tuesday 16 December 2014

Use A Corsa Exhaust On The Jeep Srt8

The SRT8 replica of Jeep Grand Cherokee is built with a high-performance engine. To receive every bit of aptitude away of the engine, one choice is to install a high-performance exhaust manner, such as those false by Corsa. These exhausts can enlargement the horsepower output since they accession the dimensions of airflow running away of the exhaust. To install a Corsa exhaust on your Jeep SRT8, you committal a uncommon hours of hour and a sporadic basic tools.


Instructions


Pull the exhaust off the connexion at the clamp with both hands, then pull the exhaust off the hangers. Unbolt the exhaust clamp located forward of the rear axle meeting with the 3/8-inch ratchet and socket, then pull off that abbreviate of the exhaust.3. Establish the exhaust hanger located on the passenger side of the Motor lorry, fair-minded above the lower bridle arm link for the rear suspension. Crawl under the SRT8 and spray all of the exhaust hangers with the soapy inundate spray.


2. Unbolt the exhaust clamps located on the exhaust over the rear axle using the 3/8-inch ratchet and socket.1. Stadium the Jeep on a comparable surface and lift it off the ground using the jack. Deposit jack stands underneath the chassis in at least four points on the vehicle.


Reduce off this hanger using the 4-1/2 inch angle grinder and the metal cut-off spin.


4. Exercise the anti-seize compound to the threads of the exhaust clamps from the Corsa exhaust equipment. Install the conduit tunnel muffler meeting from the equipment onto the exhaust flanges on the stock system using the 3/8-inch ratchet, extension and sockets and an open-end wrench.


5. Slide the exhaust section that fits over the axle onto the ends of the pipe tunnel kit and install the exhaust clamps loosely with the 3/8-inch ratchet, extension and sockets. Hang the tubing from the stock exhaust hangers.


6. Hang the rear muffler assemblies from the exhaust hangers, then bolt them to remainder of the exhaust with the exhaust clamps from the kit. Tighten up all of the exhaust fittings. Lower the Jeep off the jack stands with the jack.