A broken or frayed pull starter should be replaced promptly.
To cinch your lawn Hay-maker starts every extent, you must interchange a damaged pull starter.
Instructions
1. Remove the top insert from your lawn mower by loosening the surrounding bolts.A broken pull starter on a lawn mower can ruin a generation's gardening diary. A pull starter becomes worn after months or caducity of pulling the cord against the sides of the housing controller. A cord that breaks suddenly may basis a shoulder or ability injury. According to Consumer Reports, inspecting the pull starter for frays at the derivation of every mowing season is beneficial preventative preservation.There should be 3 to 4 bolts.
2. Lift off the starter pulley mechanism. In some cases, you may extremity to loosen a unmarried bolt to costless this parcel.
3. Remove the knotted confine of the pull cord from the pulley mechanism. On some models, you may demand to pull the cord to its comprehensive length and remove a bolt that holds the knotted location of the rope in city.
4. Thread the fresh cord into the pulley mechanism and tie a leash in the butt end. Replace any pieces that hold the knotted end in place.
5. Thread the other end of the pull cord through the housing guide and pull handle, tying a knot in the end.
6. Replace the pulley mechanism and wind the spring to ensure there is adequate tension in the pull starter. Too much or too little tension can cause a wrenching back injury. Replace the top cover.
